From c, the middle of the line A B, c a and c b, must be set off equal to the width of the back (i k), added to half its width (f i), and lines drawn from i to a, and from k to b, will show the ground plan of the fronts of the new covings.

When this is done, nothing more will be necessary than to build up the back and covings; and if the Fire- place is designed for burning coals, to fix the grate in its proper place, according to the directions already given. -- When the width of the Fire-place is reduced, the edges of the covings a A and b B are to make a finish with the front of the jambs. -- And in general it will be best, not only for the sake of the appearance of the Chimney, but for other reasons also, to lower the height of the opening of the Fire-place, whenever its width in front is diminished.

Fig. 4. shows a front view of the Chimney after it has been altered according to the directions here given. -- By comparing it with fig. 2. (which shows a front view of the same Chimney before it was altered), the manner in which the opening of the Fire-place in front is diminished may be seen. -- In fig. 4. the under part of the door-way by which the Chimney-sweeper gets up the Chimney is represented by white dotted lines. The door-way is represented closed.

I shall finish this chapter with some general observations relative to the subject under consideration; with directions how to proceed where such local circumstances exist as render modifications of the general plan indispensably necessary.

Whether a Chimney be designed for burning wood upon the hearth, or wood, or coals in a grate, the form of the Fire-place is in my opinion, most perfect when the width of the back is equal to the depth of the Fire-place, and the opening of the Fire-place in front equal to three times the width of the back, or, which is the same thing, to three times the depth of the Fire-place.

But if the Chimney be designed for burning wood upon the hearth, upon hand irons, or dogs, as they are called, it will sometimes be necessary to accommodate the width of the back to the length of the wood; and when this is the case, the covings must be accommodated to the width of the back, and the opening of the Chimney in front.

When the wall of the Chimney in front, measured from the upper part of the breast of the Chimney to the front of the mantle, is very thin, it may happen, and especially in Chimnies designed for burning wood upon the hearth, or upon dogs, that the depth of the Chimney, determined according to the directions here given, may be too small.

Thus, for example, supposing the wall of the Chimney in front, from the upper part of the breast of the Chimney to the front of the mantle, to be only four inches, (which is sometimes the case, particularly in rooms situated near the top of a house,) in this case, if we take four inches for the width of the throat, this will give eight inches only for the depth of the Fire-place, which would be too little, even were coals to be burnt instead of wood. -- In this case I should increase the depth of the Fire-place at the hearth to 12 or 13 inches, and should build the back perpendicular to the height of the top of the burning fuel, (whether it be wood burnt upon the hearth, or coals in a grate,) and then, sloping the back by a gentle inclination forward, bring it to its proper place, that is to say, perpendicularly under the back of the throat of the Chimney. This slope, (which will bring the back forward four or five inches, or just as much as the depth of the Fire-place is increased,) though it ought not to be too abrupt, yet it ought to be quite finished at the height of eight or ten inches above the fire, otherwise it may perhaps cause the Chimney to smoke; but when it is very near the fire, the heat of the fire will enable the current of rising smoke to overcome the obstacle which this slope will oppose to its ascent, which it could not do so easily were the slope situated at a greater distance from the burning fuel²

The Public in general, and more particularly those Tradesmen and Manufacturers whom it may concern, are requested to observe, that as the Author does not intent to take out himself, or to suffer others to take out, any patent for any invention of his which may be of public utility, all persons are at full liberty to imitate them, and vend them, for their own emolument, when and where, and in any way they may